Oct-2024 New Version 350-801 Certificate & Helpful Exam Dumps is Online
350-801 Free Certification Exam Material with 390 Q&As
NEW QUESTION # 203
Refer to the exhibit.
Refer to the exhibit. An administrator must fix the SRV records to ensure that server1. sample.com is always contacted first from the three servers. Which solution should the engineer apply to resolve this issue?
- A. Priority = 10, Weight = 10
- B. Priority = 100, Weight = 90
- C. Priority = 5, Weight = 70
- D. Priority = 10, Weight = 5
Answer: C
NEW QUESTION # 204
An engineer must configure switch port 5/1 to send CDP packets to configure an attached Cisco IP phone to trust tagged traffic on it's access port.
Which command is required to complete the configuration?
Router# configure terminal
Router(config)# interface gigabitethernet 5/1
Router(config-if)# description Cube E42.421-5965
- A. platform qos trust extend cos 5
- B. platform qos trust extend cos 3
- C. platform qos trust extend
- D. platform qos extend trust
Answer: C
NEW QUESTION # 205
Given the H.323 gateway configuration and using Cisco best practices, how must the called party transformation pattern be configured to ensure that a proper ISDN type of number is set?
- A.
- B.
- C.
- D.
- E.
Answer: C
NEW QUESTION # 206
An engineer wants to manually deploy a Cisco Webex DX80 video endpoint to an end user.
Which type of provisioning can be configured on the endpoint?
- A. CUCM
- B. CUBE
- C. Edge
- D. CMS
Answer: A
Explanation:
https://www.cisco.com/c/en/us/products/collateral/collaboration-endpoints/desktop-collaboration- experience-dx600-series/datasheet-c78-731879.html
NEW QUESTION # 207
Drag and Drop Question
Drag and drop the SNMPv3 message types from the left onto the corresponding definitions on the right.
Answer:
Explanation:
NEW QUESTION # 208 
Refer to the exhibit. An engineer is troubleshooting a codec negotiation issue where both endpoints that are involved in the call support the codecs listed in the exhibit. Which audio codec is selected if a call between two endpoints in Region1 is placed?
- A. G.711a
- B. G.729
- C. G.722
- D. G.711u
Answer: C
Explanation:
Section: Protocols, Codecs, and Endpoints
Explanation
NEW QUESTION # 209
Refer to the exhibit.
The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?
- A. The translation rule is matched and the translated number is 025553431234.
- B. The translation rule is not matched because DNIS does not end with a "$".
- C. The translation rule is matched and the translated number is 02553431234.
- D. The translation rule is not matched because DNIS contains "-".
Answer: C
NEW QUESTION # 210
Given this H.323 gateway configuration and using cisco best practices, how must the called party transformation pattern to ensure that a proper ISDN type of number is set?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option C
- D. Option B
Answer: B
NEW QUESTION # 211
Refer to the exhibit. How must the +E.164 translation pattern be configured to reach international number 496929810?
- A. Pattern= \+.496929810, CSS=Unrestricted-CSS, PreDot, Prefix=777011
- B. Pattern= \+.496929810, CSS=Intl_CSS, PreDot, Prefix=777011
- C. Pattern= \+.011496929810, CSS=Global-CSS, PreDot, Prefix=777
- D. Pattem= \+.777011496929810, CSS=Intl_CSS
Answer: B
Explanation:
B is incorrect since it doesn't state in the answer that the translation pattern will discard the
"Pre.Dot", which means the final pattern will have the "+" sign at the beginning which will not match the route pattern in the screenshot which doesn't have a "+" sign, however if we use the translation pattern in Answer D we will be able to achieve that since the "+" will be discarded and
777011 will be prefixed so the final pattern will be 777011496929810 == Match.
NEW QUESTION # 212
What is the most efficient way to configure a speed dial to number 1111 on multiple phones using the Self-Provisioning feature in Cisco UCM?
- A. Configure each phone with the same DN and then configure a speed dial of 1111 on one of the phones manually by navigating to Devices>Phones and modifying the phone. This will automatically replicate to all the other phones.
- B. Configure a universal device template that has speed dials in the phone button configuration field, then allow the user to specify 1111 as a speed dial via the Cisco Unified Communications Self Care Portal.
- C. Configure the phones with a phone button template that has speed dials then specify 1111 as a speed dial via BAT>Phones>Add/Update phones web page to specify the speed dial number after the phone is in Cisco UCM.
- D. Configure a universal device template that has speed dials in the phone button configuration field, then specify 1111 as a speed dial by editing the speed dial within the universal device template.
Answer: D
NEW QUESTION # 213
An administrator troubleshoots call flows and suspects that there are issues with the dial plan Which tool enables a quick analysis of the dial plan and provides call flows of dialed digits?
- A. Dialed Number Analyzer
- B. Digit Analysis Analyzer
- C. Cisco Dial Plan Analyzer
- D. Dial Plan Analyzer
Answer: A
NEW QUESTION # 214
When configuring Cisco Unified Communications Manager, which configuration enables phones to automatically register to a Cisco Unified Communications publisher when the connection to the subscriber is lost?
- A. Cisco Unified CM Group
- B. Route Group
- C. SRST
- D. Device Pool
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/ guide/SCCP_and_SIP_SRST_Admin_Guide/srst_overview.html
NEW QUESTION # 215
What is the major difference between the two possible Cisco IM and Presence high-availability modes?
- A. Balanced mode provides user load balancing and user failover in the event of an outage. Active/standby mode provides an always on standby node in the event of an outage, and it also provides load balancing.
- B. Balanced mode provides user load balancing and user failover only for manually generated failovers.
Active/standby mode provides an unconfigured standby node in the event of an outage, but it does not provide load balancing. - C. Balanced mode does not provide user load balancing, but it provides in the event of an outage. Active/ standby mode provides an always on standby node in the event of an outage, but it does not provide load balancing.
- D. Balanced mode provides user load balancing and user failover in the event of an outage. Active/standby mode provides an always on standby node in the event of an outage, but it does not provide load balancing.
Answer: D
NEW QUESTION # 216
When a phone is registered over Mobile and Remote Access, where does it register?
- A. Expressway-E
- B. Cisco Unified Communications Manager
- C. Cisco Unified Presence Server
- D. Expressway-C
Answer: A
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/ cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_01011010.html
NEW QUESTION # 217
Which packet delay is the maximum supported between Cisco Unified Communications Manager nodes for clustering over WAN deployments?
- A. 510 ms round trip
- B. 150 ms round trip
- C. 40 ms round trip
- D. 80 ms round trip
Answer: D
NEW QUESTION # 218
Refer to the exhibit.
Refer to the exhibit. The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?
- A. The translation rule is matched and the translated number is 025553431234.
- B. The translation rule is not matched because DNIS does not end with a "$".
- C. The translation rule is not matched because DNIS contains"-".
- D. The translation rule is matched and the translated number is 02553431234.
Answer: D
NEW QUESTION # 219
An administrator is asked to implement toll fraud prevention in Cisco UCM, specifically to restrict off-net to off-net call transfers How is this implemented?
- A. Use the correct route filters.
- B. Enforce ad-hoc conference restrictions
- C. Implement time-of-day routing.
- D. Set the appropriate service parameter
Answer: D
NEW QUESTION # 220
Refer to the exhibit.
Refer to the exhibit. An administrator must replace the T1 card with an E1 card. What is the correct configuration if the administrator was asked to configure 12 time slots?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 221
Refer to the exhibit. Which Codec is negotiated?
- A. G.729
- B. G.711ulaw
- C. iLBC
- D. G.728
Answer: B
NEW QUESTION # 222
An administrator needs to create a partial PRI consisting of the first seven timeslots available. Which configuration snippet configures the ISDN E1 PRI for this task?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION # 223
An administrator is configuring LDAP tor Cisco UCM with Active Directory integration. A customer has requested to use "ipphone" instead of "telephoneNumber" as the phone number attribute. Where does the administrator specify this attribute mapping in Cisco UCM?
- A. LDAP Custom Filter
- B. LDAP Directory user fields
- C. LDAP Authentication
- D. LDAP Directory custom user fields
Answer: B
NEW QUESTION # 224
The IP phones al a customer site do not pick an IP address from the DHCP An engineer must temporarily disable LLDP on all ports of the switch to leave only CDP. Which two commands accomplish this task? (Choose two.)
- A. Switch(conlicj)# interface GigabitEthernet1/0/1
- B. Switch(config># no lldp transmit
- C. Switch# copy running-config startup-config
- D. Switch(config)# no lldp run
- E. Switch# configure terminal
Answer: D,E
NEW QUESTION # 225
Which datastore and protocol is used for saving back-up files within the Disaster Recovery System of Cisco UCM?
- A. remote disk on an NFS share
- B. local disk on the Cisco UCM server
- C. remote disk on a CIFS share
- D. remote disk on the SFTP server
Answer: D
Explanation:
Section: Infrastructure and Design
Explanation/Reference: https://www.learncisco.net/courses/cucm-basics/serviceability-backup-and-restore/backing-up-and- restoring-cucm.html
NEW QUESTION # 226
Due to service provider restriction, Cisco Unified Communications Manager cannot send video in the SDP. Which two options on Cisco Unified CM are configured to suppress video in the SDP is outgoing invites? (Choose two.)
- A. Set Video bandwidth in the Region settings to 0.
- B. Change the Video Capabilities dropdown on the endpoint to Disabled.
- C. Add the audio forced command to voice service voip on the Unified Border Elements.
- D. Check the Retry Call as Audio on the SIP trunk
- E. Check the Send send-receive SDP in mid-call INVITE check box on the SIP trunk SIP profile.
Answer: A,B
NEW QUESTION # 227
A user forwards a corporate number to an international number. What are two methods to prevent this forwarded call? (Choose two.)
- A. Set the Call Classification to OnNet for the international route pattern.
- B. Set Call Forward All CSS to restrict international dial patterns.
- C. Block international dial patterns in the SIP trunk CSS.
- D. Check Route Next Hop By Calling Party Number on the international route pattern.
- E. Configure a Forced Authorization Code on the international route pattern.
Answer: C,E
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/ cmeadm/cmetrans.html
NEW QUESTION # 228
......
Get The Important Preparation Guide With 350-801 Dumps: https://lead2pass.prep4sureexam.com/350-801-dumps-torrent.html